I got tired of always having to adjust/tweak the printer after about 6 month of ownership. Try the stock firmware, if it work for you and you can manage to set it up properly and have constant results, stick with that, don't bother with this walkthru. The AC female plug on mine gave up after about 6 month probably because i didn't check when i got my printer. Check every electrical's connections, Everything with a screw or connector should be secure properly, no loose connection.Check every mechanical fastener, make sure all the screw are thight, no slack with the rollers, etc.A runout detection sensor that has a brass or other strong material insert at the input side, your filament is going to cut right thru the stock all plastic Tronxy sensor after a while.24V/50W Heater rod, chances are they installed a cheap 12V/50W Heater rod in your machine and it's going to burn itself after a few prints.At least one 1Kg roll of PLA or wathever material you prefer that you don't mind throwing in the garbage.A full pot of coffee (or 10 full pots).This is only for the Tronxy XY-2 Pro, non-titan.This is a work in progress, things may and will change in the futur. No waranty whatsoever that this will work for you. Restore stock Tronxy firmware and settings.

Tronxy xy 2 firmware update